Malays. J. Anal. Sci. Volume 30 Number 5 (2026): 1908

 

Research Article

 

Synthesis of carbon quantum dots from disposable surgical masks for UV- induced apparent Eriochrome black T removal

 

Emerson De Los Reyes, Pauline Andres, Norelyn Arenas and Chelsea Allyssa Rayo, and Rhonalyn Maulion*

 

Department of Chemical Engineering, College of Engineering, Batangas State University, The National Engineering University – Alangilan Batangas City, Batangas, 4200, Philippines

 

*Corresponding author: rhonalyn.maulion@g.batstate-u.edu.ph

 

Received: 16 April 2026; Revised: 10 July 2026; Accepted: 25 September 2026; Published: 31 October 2026

 

Abstract

The persistence of synthetic dyes in wastewater and the increasing accumulation of disposable surgical mask (DSM) waste represents concurrent environmental challenges that require sustainable solution through waste valorization strategies. Eriochrome Black T (EBT), an anionic azo dye, is of particular concern due to its chemical stability and resistance to biodegradation. Although carbon quantum dots (CQDs) have gained attention for environmental applications, limited studies have explored waste DSMs as carbon precursors for CQD synthesis and their application in apparent EBT removal. To address this gap, CQDs were synthesized from previously used DSMs via microwave-assisted method using ethylenediaminetetraacetic acid (EDTA) as a nitrogen-containing agent and evaluated for apparent EBT removal under UV irradiation. A face-centered central composite design was used to optimize synthesis conditions that yield a maximum photoluminescence (PL) intensity of 175.379 at 1 g DSM precursor, 630 W microwave power, and 15 min irradiation time. Analysis of variance at a 95% confidence level showed that DSM mass, microwave power, and irradiation time significantly affected the photoluminescence (PL) response. TEM analysis revealed an average particle size of 10.5 nm and a lattice fringe spacing of 0.316 nm. FTIR-ATR indicated surface functionalities potentially associated with O–H/N–H and C=C and/or C=N vibrations, while UV–Vis spectra exhibited π–π* and n–π* transitions. PL spectroscopy showed excitation and emission maxima at 363 and 461 nm respectively. The UV-induced apparent EBT removal performance was evaluated by varying initial EBT concentration, CQD suspension volume, and contact time. QCDs showed moderate UV induced EBT removal activity with 51.45% achieved after 5 hours of UV exposure. These findings suggest the potential of DSM-derived CQDs as value-added fluorescent nanomaterials for dye-removal applications.

 

Keywords: surgical mask carbon quantum dots, apparent EBT removal, microwave-assisted extraction, Eriochrome black T

 


References

1.        UNESCO World Water Assessment Programme (2024). The United Nations World Water Development Report 2024: Water for Prosperity and Peace. Access from https://www.unwater.org/publications/un-world-water-development-report-2024. [Access online 24 March 2026].

2.        Islam, M. M., Rahman, M. M., and Hasan, M. T. (2025). A critical review on textile dye-containing wastewater: Ecotoxicity, health risks and remediation strategies for environmental safety. Cleaner Chemical Engineering, 11: 100165.

3.        Singh, B. J., Kumar, P. and Sharma, R. (2023). A systematic review of industrial wastewater management: Evaluating challenges and enablers. Journal of Environmental Management, 348: 119230.

4.        Çetinkaya, H. F., Aydin, S. and Yilmaz, A. (2025). Biosorptive removal of textile dye Eriochrome Black T from aqueous solution. Journal of Molecular Liquids, 408: 125015.

5.        Lellis, B., Fávaro-Polonio, C. Z., Pamphile, J. A., & Polonio, J. C. (2019). Effects of textile dyes on health and the environment and bioremediation potential of living organisms. Biotechnology Research and Innovation, 3(2), 275–290.

6.        Chatla, A., Almanassra, I. W., Kochkodan, V., Laoui, T., Alawadhi, H., & Atieh, M. A. (2022). Efficient removal of eriochrome black T (EBT) dye and chromium (CR) by hydrotalcite-derived MG-CA-AL mixed metal oxide composite. Catalysts, 12(10), 1247.

7.        Slama, H. B., Bouket, A. C., Pourhassan, Z., Alenezi, F. N., Silini, A., Cherif-Silini, H., et al. (2021). Diversity of synthetic dyes from textile industries, discharge impacts and treatment methods. Applied Sciences, 11(14), 6255.

8.        Yalshetti, S., Patil, A., Patil, S. and Gasti, T. (2024). Microwave-assisted synthesis, characterization and biomedical applications of carbon quantum dots: A review. Nanomaterials, 14 (5): 420 – 436.

9.        Shaik, S. A., Sengupta, S., Varma, R. S., Gawande, M. B., & Goswami, A. (2020). Syntheses of N-doped carbon quantum dots (NCQDs) from bioderived precursors: A timely update. ACS Sustainable Chemistry & Engineering, 9(1), 3–49.

10.     Aragaw, T. A. (2020). Surgical face masks as a potential source for microplastic pollution in the COVID-19 scenario. Marine Pollution Bulletin, 159: 111517.

11.     Bumajdad, A., & Khan, M. J. H. (2021). The reuse of disposable COVID-19 surgical masks as a nitrogen-enrichment agent and structure promotor for a wild plant-derived sorbent. Journal of Industrial and Engineering Chemistry, 102, 163–176

12.     Xu, Q., Kuang, T., Liu, Y., Cai, L., Peng, X., Sreeprasad, T. S., et al. (2016). Heteroatom-doped carbon dots: synthesis, characterization, properties, photoluminescence mechanism and biological applications. Journal of Materials Chemistry B, 4(45), 7204–7219

13.     Canson, M., Cantos, J., & de Guzman, M. (2016). Modelling the effect of varying Cr+6 and Cu+2 concentration on the luminous intensity of photobacterium phosphoreum in simulated seawater. Thesis Bachelor of Chemical Engineering.

14.     Najjar, M., Nasseri, M. A., Allahresani, A., & Darroudi, M. (2022). Green and efficient synthesis of carbon quantum dots from Cordia myxa L. and their application in photocatalytic degradation of organic dyes. Journal of Molecular Structure, 1266, 133456.

15.     Kausar, A. (2022). Polymeric Nanocomposites with Carbonaceous Nanofillers for Aerospace Applications. Elsevier.

16.     Anuar, N. K. K., Tan, H. L., Lim, Y. P., So’aib, M. S., & Bakar, N. F. A. (2021). A review on Multifunctional carbon-dots synthesized from biomass waste: design/ fabrication, characterization and applications. Frontiers in Energy Research, 9, 626549.

17.     Farsi, B. A., Sofin, R. G. S., Shidhani, H. A., El-Shafey, E.-S. I., Al-Hosni, A. S., Marzouqi, F. A., et al. (2022). The effect of microwave power level and post-synthesis annealing treatment on oxygen-based functional groups present on carbon quantum dots. Journal of Luminescence, 252, 119326.

18.     Ghanem, A., Al-Marjeh, R. A.-Q. B., & Atassi, Y. (2020). Novel nitrogen-doped carbon dots prepared under microwave-irradiation for highly sensitive detection of mercury ions. Heliyon, 6(4), e03750.

19.     Song, Z., Chen, X., Gong, X., Gao, X., Dai, Q., Nguyen, T. T., & Guo, M. (2020). Luminescent carbon quantum dots/nanofibrillated cellulose composite aerogel for monitoring adsorption of heavy metal ions in water. Optical Materials, 100, 109642.

20.     Dela Cruz, Ma. I. S., Thongsai, N., De Luna, M. D. G., In, I., & Paoprasert, P. (2019). Preparation of highly photoluminescent carbon dots from polyurethane: Optimization using response surface methodology and selective detection of silver (I) ion. Colloids and Surfaces a Physicochemical and Engineering Aspects, 568, 184–194.

21.     Mondal, T. K., Dinda, D., & Saha, S. K. (2018). Nitrogen, sulphur co-doped graphene quantum dot: An excellent sensor for nitroexplosives. Sensors and Actuators B Chemical, 257, 586–593.

22.     Wang, R., Wang, X., & Sun, Y. (2016). One-step synthesis of self-doped carbon dots with highly photoluminescence as multifunctional biosensors for detection of iron ions and pH. Sensors and Actuators B Chemical, 241, 73–79

23.     Singh, A., Qu, Z., Sharma, A., Singh, M., Tse, B., Ostrikov, K., et al. (2022). Ultra-bright green carbon dots with excitation-independent fluorescence for bioimaging. Journal of Nanostructure in Chemistry, 13(3), 377–387.

24.     Ozyurt, D., Kobaisi, M. A., Hocking, R. K., & Fox, B. (2023). Properties, synthesis, and applications of carbon dots: A review. Carbon Trends,   12, 100276.

25.     Nguyen, K. G., Baragau, I. A., Gromicova, R., Nicolaev, A., Thomson, S. A., Rennie, A., ... & Kellici, S. (2022). Investigating the effect of N-doping on carbon quantum dots structure, optical properties and metal ion screening. Scientific         Reports, 12(1), 13806.

26.     Lazar, P., Mach, R., & Otyepka, M. (2019). Spectroscopic fingerprints of graphitic, pyrrolic, pyridinic, and chemisorbed nitrogen in N-doped graphene. The Journal of Physical Chemistry C, 123(16), 10695-10702.

27.     Patir, K., & Gogoi, S. K. (2018). Nitrogen-doped carbon dots as fluorescence ON–OFF–ON sensor for parallel detection of copper(II) and mercury(II) ions in solutions as well as in filter paper-based microfluidic device. Nanoscale Advances, 1(2), 592–601.

28.     Zaib, M., Akhtar, A., Maqsood, F., & Shahzadi, T. (2021). Green synthesis of carbon dots and their application as photocatalyst in dye degradation studies. Arabian Journal for Science and Engineering, 46(1), 437-446.

29.     Abd Rani, U., Ng, L. Y., Ng, C. Y., Mahmoudi, E., Ng, Y. S., & Mohammad, A. W. (2021). Sustainable production of nitrogen-doped carbon quantum dots for photocatalytic degradation of methylene blue and malachite green. Journal of Water Process Engineering, 40, 101816.

30.     Karim, S., Ahmad, N., Hussain, D., Mok, Y. S., & Siddiqui, G. U. (2022). Active removal of anionic azo dyes (MO, CR, EBT) from aqueous solution by potential adsorptive capacity of zinc oxide quantum dots. Journal of Chemical Technology & Biotechnology, 97(8), 2087-2097.

31.     Abdolahi, G., Dargahi, M., & Ghasemzadeh, H. (2020). Synthesis of starch-g-poly(acrylic acid)/ZnSe quantum dot nanocomposite hydrogel, for effective dye adsorption and photocatalytic degradation: thermodynamic and kinetic studies. Cellulose, 27(11), 6467–6483.

32.     Yadav, S., Kumar, A., & Kumar, D. (2023). Photo degradation of methylene blue onto Boron/Phosphorous modified carbons dots prepared by hydrothermal and microwave assisted methods. Materials Science for Energy Technologies, 6, 260-266.